Angel Hair Rusty olive (Small patch under the tail)
Barred rabbit strip Two-tone black over yellow/orange (1 strip for the tail)
Wire Hot orange or red wire (Small, for the dubbing brush)
Senyo Laser Dub Sculpin olive (Body brush plus a pinch for the head)
Sili Legs Fire-tip sand and orange, barred (1 leg, cut in half)
UV resin (Solarez Bone Dry) (For the head)
How to tie it
Crimp the barb, start the red 6/0 thread, and figure-eight a pair of large bead chain eyes on top of the shank behind the eye.
At the rear, tie in a small patch of rusty olive Angel Hair so it veils the hide of the rabbit strip and peeks out behind it.
Tie in the barred rabbit strip tail with good tight turns. Make it long, two to three times the body length, so it breathes and swims.
Tie in the small red wire at the rear. Lay sculpin olive Laser Dub over the waxed wire with the fibers straight and level, then spin it into a dubbing brush until it locks up tight.
Wrap the brush forward, teasing the fibers back with each turn so nothing gets trapped, and tie off right behind the bead chain eyes.
Pick the body out with a bodkin and brush it rearward into a tapered minnow profile, a little red wire and thread glinting through the bottom is fine.
Cut the barred Sili Leg in half and lash one piece along each side at mid-body so a kicker points out the front and another trails around the back on each side.
Gather one more pinch of Laser Dub for the head: pinch it down over the top between the eyes, fold it underneath, and bind. Mind the hook point.
Whip finish, then coat the head and thread with Bone Dry UV resin and cure with the torch.