Hook Hanak 400BL - (any jig hook and 10, 12, and 14, 12
Thread Olive UTC 70
Materials
Bead Copper Tungsten - 4.0 mm (I like 3.8, 4.0, and 4.4mm beads for this one)
Body 2 strands Pearl Krystal Flash (Play around with colors and material)
Ribbing UTS Ultra Wire - Silver, size Small
Hackle Hareline Crosscut Rabbit Strips used as dubbing - Olive (play with colors - all kinds work great!)
Collar Fluorescent Orange UTC 70
How to tie it
Slide the 4.0mm Copper Tungsten bead onto the Hanak 400BL, start the Olive UTC 70 behind it and build a small thread bump to hold the bead in place, then wrap back to the bend.
Bind the UTS Ultra Wire Silver along the side of the shank down to the bend.
Fold the 2 strands Pearl Krystal Flash around the thread, bind them down to the bend, bring the thread forward to about one eye-width behind the bead and throw a half hitch.
Wrap the Krystal Flash forward from the bend to the collar point — the body stays very sparse — tie off and trim.
Counter-wrap the wire forward in the opposite direction to the flash as an open rib to protect the body; tie off and helicopter the wire to break it.
Form a dubbing loop, lay a short section of Olive crosscut rabbit fur into it, spin with a dubbing tool, and wrap one to three turns, sweeping the fur down and back as you go. Keep it sparse. Tie off, snip the loop and throw a couple of half hitches.
Start the Fluorescent Orange UTC 70 behind the bead, build a collar and whip finish.
Pull the fur back and put UV clear finish on the collar thread only, then cure with the UV light for a few seconds.